Fits 1979-1987 GM C10 Trucks

Part Number: 320-323

These Holley steering shaft kits were designed to replace a worn stock one on your latter years' 3rd generation GM C10 trucks or with an engine swap where additional clearance may be needed. With sturdy DD-style steel shafts and dual u-joints, there is plenty of adjustability for your project to ensure everything is exact and safe. *See Holley Part # 320-322 for 1973-1978 C10 Steering Shaft

Features and Benefits

• Complete bolt-on solution with little or no modifications necessary depending on use
• Eliminates factory rag joint providing a precise and responsive steering input
• Will also work as a factory replacement steering shaft
• E-Coat for maximum protection against corrosion
• Steel construction with retaining screws on the bearing caps for strength and durability

It is extremely important that these steering shafts are installed by a qualified technician. Failing to do so will result in an unsafe vehicle._x000D_ _x000D_ If installing these shafts with an OE steering box, you may need to trim the pin on the input shaft for U-joint clearance._x000D_ _x000D_ Loctite 242, extra grease, and a torque wrench are highly recommended!!!