Multi Caliber Mini Case Feeder for Dillon XL650 and XL750 reloading presses.

If you have started reloading on the XL650/750 without the optional case feeder, the DAA Mini Case Feeder will be a great addition to your press.

In a few minutes, the Mini Case Feeder allows you to pre-load 6 tubes with a total of 150 9MM cartridges (about 130 of .40, or 120 of 38S).

Using the included DAA Adaptor Set parts, you simply seat the magazine atop your XL650/750 using the Casefeed Adaptor, click the first tube into place – and you are ready to go. Each time a tube empties out, click the next one into position and continue reloading.

DAA XL650 Mini Case Feeder includes:

• 1x 6-tube magazine assembly
• 1x Multi-Cal Adaptor-Set

The new design uses your original caliber specific Casefeed Adaptor, so you can use your DAA Mini Case Feeder to feed brass in any caliber.

This is product can handle: 9MM, 38S, 38SPL, 357, 0.40, 10MM, .45, .44, 223 and more.

Additional Magazine Assemblies can be purchased separately should you wish to prepare more than 150 pcs of brass in advance.

Note

• The Multi-Cal Adaptor Set is designed to fit snugly onto the Dillon Casefeed Adaptor tubes. If too tight, it may be difficult to remove to clear jams. If too loose, the assembly may wobble or cant a little. There is a slight variance between the various Dillon Casefeed Adaptor tubes, so some light fitting may be needed for a fit perfect to your needs. You can use a file, sandpaper or dremel to slightly increase the inner dimension of the Support Ring part.
• When filling tubes, rotate the assembly base so that its positioned between tubes. This way none of the columns line up with the hole in the bottom – and the brass won’t fall out too early.